Page 7 - Microsoft Word - 4236
P. 7

1 GEOMETRICAL AND PROJECTING DRAWING
                           1.1 COMMON RULES OF DRAFT SHAPING AND FINISHING


                   When shaping and finishing drafts it is obligatory keep strictly to demands of State
                 Standards.
                  Formats State Standard 2.301-68*
                  The standard sizes of a drawing sheets are given in Table 1.1.


                  Table 1.1– Standard sizes of a drawing sheets
                   Denotation             A0            A1            A2            A3            A4


                  Sizes of sides,      841x1189      594x841       420x594       297x420       210x297
                   mm x mm



                  The layout of drawing sheet is shown in Fig. 1.1.
                  The title block takes place along longer or shorter side of format on all of formats (except for
            A4). Title block is stirred only along shorter side on the sheets of format of A4 (fig.1.1, b).





















                                a                                                       b
                                                 Figure 1.1 - Title block

                  There are three forms of title block. Title block (form 1) is intended for all of cases of
            drawings and charts is shown in figure 1.2















                                                            a













                                                                                                            7
   2   3   4   5   6   7   8   9   10   11   12