Page 82 - 5010
P. 82

the loading element); the recording length on time is 120 ± 5 mm.

                        On  basis  of  data from table 11.1  it is possible to generalize the

                  technical  characteristics  for  the whole series (row) of  the downhole
                  pressure gage DPGNS-2 (МГН-2):

                  the range of  pressure measuring is from 10 to 100 MPa;
                                                                      о
                  the maximum temperature is 100 or 160  С;
                  the pressure gage error is  ± 0.25 or ± 0.4 % of the upper limit of  the

                  measurement;

                  the recording length on pressure is 50 ± 5 mm (45 ± 5 mm);
                  the recording length on time is 120 ± 5 mm;
                  sizes:  the  length is  from  1500  до  1800  mm  (the  length with  the

                  loading element and thermometer part is up to 2300 mm), the diameter
                  is 32 − 36 mm;
                  the mass is not bigger than 10 kg (without the loading element).

                        The  helix  downhole   pressure  gage  DPGT-1  (МГТ-1).  The

                  helix  downhole   pressure  gage  DPGT-1  (МГТ-1)  is  applied  for
                  control  of  the  pressure on the bottom hole  of  the wells into which
                  hot  water or moisten steam is pumped under the temperature up to
                                 о
                  350 – 400   С. The measured pressure is transmitted to the helix string
                  hollow through the screen filter. The main feature  of  the downhole
                  pressure  gage  DPGT-1  (МГТ-1) is   the  absence  of   the  clockwork
                  drive  in  the  recording  part of  the  device.  In this  downhole pressure

                  gage the loads are used instead of  it. These loads by  means of rack,
                  locking  device and  clamp  dog   at  the  sharp  braking  or  jerk of   the
                  device  by a wire (cable) move downwards under their own momenta.

                  Thus the pressure  measured  at  the moment of  jerk  of  the  device  is

                  recorded on the blank. It is possible to record 10 − 15 magnitudes of
                  the pressure in arbitrarily chosen moments of time during the device

                  operation.

                        Downhole pressure  gages  DPGFT-1M  (МГИ-1М)  and

                  DPGFT-3  (МГИ-3). Helix  downhole  pressure  gages  DPGFT-1M
                  (МГИ-1М)  and  DPGFT-3  (МГИ-3)  are  applied  for  recording
                  pressures at well  testing  by  means  of  the pipe  formation  testers.  In

                  these  devices  recording  the  pressure change  starts  only after  the
                  formation  tester  reaches  the  necessary  depth.   Comparatively  with
                  downhole  pressure  gage  DPGNS-2  (МГН-2)  there   are  many
                  structural  changes  in  downhole  pressure  gages  DPGFT-1M  (МГИ-



                                                              81
   77   78   79   80   81   82   83   84   85   86   87